Ocean-optics ISS User Manual download pdf

ISS Integrated Sampling System

The ISS INTEGRATED SAMPLING SYSTEM is a fully integrated 1-cm cuvette holder and tungsten halogen light source.

It couples to our spectrometers with optical fiber to create a small-footprint systems for VIS-NIR (~360-1100 nm).

The ISS has a 10,000 hour bulb and the fan is enclosed in the base.

Parts Included

! ISS cuvette holder and light source assembly

! 12VDC wall transformer for providing power

! 1-cm square, plastic cuvette for holding samples

! Screwdriver for adjusting the fit of the cuvette

! Allen wrench for adjusting the collimating lens

Operation

Attaching the Fibers

1. Attach a SMA-terminated optical fiber to the collimating lens.

2. Attach the other end of this fiber -- the read fiber -- to the spectrometer.

Adjusting the Fit of the Cuvette

The ISS is preset for use with a 1-cm cuvette. When properly adjusted, the cuvette should fit snugly into the holder.

1. Locate the two ball plunger screws.

2. Use the screwdriver to loosen the two ball plunger screws until the ends are visible in the holder.

3. Insert your cuvette into the holder.

4. Tighten the screws until the ball contacts the cuvette and starts to compress. Do not over-tighten.

Installing Filters

1. Loosen the filter clamping screw with an Allen wrench.

2. Insert the filter into the filter slot. The filter slot can accommodate filters up to 6 mm thick.

3. Clamp the filter in place by gently tightening with an Allen wrench.

Turning On the Lamp

1. Plug the wall transformer end into a 110 V outlet. Plug the 12 V output end into the back of your ISS.

2. Screw a fiber into the SMA connector.

3. Find the on/off switch on the back of the lamp and turn the lamp on.

Replacing the Bulb on the ISS

1. Order a replacement bulb.

2. Turn off the lamp and allow it to cool.

3. Use your Allen wrench to loosen the set screw on the bottom of the lamp. You do not need to remove the set

screw. This screw holds the bulb in place.

4. Locate the two set screws at the back of the lamp, one above each back leg. These two screws keep the two

halves of the lamp together. Remove the two screws.

5. Gently separate the two halves of the lamp and pull the bulb out of its housing.

6. Detach the wire and socket from the lamp leads. Remove the old bulb unit and discard.

7. Plug the new bulb into the socket and slide it forward into the front of the lamp as far as it will go.

Operating Instructions: ISS

-1 -

1 2

Summary of Contents

Page 1 - Operation

ISS Integrated Sampling SystemThe ISS INTEGRATED SAMPLING SYSTEM is a fully integrated 1-cm cuvette holder and tungsten halogen light source.It couple

Page 2 - Specifications

8. Tighten the set screw on the bottom of the lamp.9. Close the two halves without pinching the wires. Replace the two screws at the back of the lamp.

Comments to this Manuals

No comments

Ocean-optics ISS User Manual

Browse online or download User Manual for Equipment Ocean-optics ISS. Ocean Optics ISS User Manual [en]

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Ocean-optics ISS